Wood Preservation Methods
The study of wood as a renewable material and organic material is what is known as wood science. In other words, the term wood science can also be known as wood technology. Wood is treated as a material in direct comparison with other products. The wood is checked against the other materials properties, performances, value, and work-ability. Wood has many advantages and this technology takes the advantages and utilizes them. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. Once a tree has been cut down another can be planted in the same spot. All the parts of wood can be put into use, and this makes it a better fit than other materials which most of their byproducts are a waste.
The good appearance of your timber made structure cannot be guaranteed if protection of the timber is not done. Wooden structures have to be kept away from water and pests that eat through the wood. The water particles in the timber increase the rotting and the insects bore through the wood. Many methods are available in the treatment of wood one of the most common being the ACQ – alkaline copper Quaternary. As the name implies the preservative is made of copper products. As effective as this preservative, it has some downside to its use. It has been seen corroding most metals for example aluminum in less than six months of its application. The saturation level of any treatment will depend on where the wood is going to be used and the species of the wood. Timber being used around a water body will be dipped in a more saturated fluid than that being used above ground.
Many methods are being invented to protect the wood, and one of them is the copper metal method. The use of this method is fast being accepted because it is not corroding the metal fasteners. Micronized copper wood preservative is the correct term to refer this type of preservation. The copper metal is applied to the wood as small microscopic particles injected into the wood at high pressure. The process eliminates the need to dissolve the copper as is done in earlier copper-based preservatives. The characteristics of the wood are highly improved and the when this process is used to treat wood. The wood products protected using this method last longer.
Termites cannot eat through timber treated through this method. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. Extensive research over a period of 10 years has proven the effectiveness of this science as one of the best wood preservation methods.